HumanCentric VESA Mount Adapter Compatible with Asus Monitors MX239H, MX259H, MX279H, MX299Q, MX25AQ, and MX27AQ, Does not fit VX Series

$15 is a fair and reasonable price. I believe this is about half the price of the prior iteration.Bottom line... does what it should.Other notes:The monitor does sit higher than other monitors, which have a built-in VESA mount, due to the fact this mount isn't very tall and the VESA mounting holes wind up near the bottom half of the monitor. But that's probably a mechanical trade-off, as any taller mount would increase the moment arm and make it almost impossible for a monitor arm's tilt not to tilt downward, due to gravity. As it is, I had to tighten the tilt more than normal due to the design of the ASUS monitor's support arm.There's a little give on the mount, when mounted and in use. Makes fine tuning a bit tough. But once it's set, it's stable. The contact area, where the back of the monitor's mount contacts the mounting slot on the adapter is not fully flushed. The back of the monitor's mount is slightly curved, while the adapter slot is straight. This is the primary cause of the slight instability, when trying to fine adjust the mount. The contact point between the monitor mount and the adapter is too small.These are nit-picks. This is a fine solution to an ASUS design flaw (i.e. not including VESA mounting holes).Thank you, HumanCentric!

Not too much to say. It fit like a glove and doesn't feel flimsy. Goes on with no issue and was decently priced

The bracket works on a MX27A (similar to the MX27AQ listed above). The sheet metal is a little thin for the cantilevered monitor weight so they wiggle when the supporting table is bumped. As mentioned in other reviews, the included screw that mounts the monitor base to the bracket is too short. Use an M6x15 if only using a flat washer or an M6x20 if using a flat washer + split lock washer as I did.

It does the job and works sufficiently. However, the screw that came to attach the mount to the monitor did not fit. The good news is the screw on the existing mount worked. While this does work for my setup, it does not mount or hold it as securely as other mounts. This is made for specific monitors, but it feels a little "wobbly" and while it holds it firmly in place, as you move the monitor, it takes some time to get it properly in place compared to other mounts. That is just one of the trade-offs when you have a monitor without a VESA mount. So yes, this does the job, but all my future monitors will have a built-in VESA mount.

It works as it says it does, but it could use a little more to make is a tad bit sturdier for my use. I swing the monitor around a lot and always feels flimsy.

Very happy, didn't a VESA mount until I did and found out that my ASUS Designo MX27AQ didn't have a VESA mount...So yea, look at the photos, the adaptor works perfect, very solid metal, no mounting issues whatsoever.IF you look at the screen from above, you're fine, but if you have the screen high and are looking from below, you WILL see this mount as it sits about 3/4 below the monitor itself (that's the way ASUS designed their monitor)

This item is terrible! It is so poorly thought out and designed. It causes the monitor to be very floppy and the mounting is very loose, no matter how tight you secure the bolt or how closely you follow directions. My monitor flopped over towards me while attached to this mount and the power connector inside the monitor broke loose. This product needs to be taken off the shelves.

Works well and solved the mounting issue that the poor design of my monitor created. Strong and it fit the standard mount all I could really ask for