smaate 3D Screen Protector Compatible with Smartwatch SKG V7, ID206 of JIKKO AOKESI HAFURY, Cubitt CT2PRO, Doogee CS2Pro, UMIDIGI UFit Pro, Fitpolo Gydom FVYAO IDO Veryfit ID207, Pupuskyer P25 1.69”

It seemed easy enough to install, but there were small bubbles that I could not get out. I pushed towards the corner based on instructions and it split the bubbles and created more. I decided to remove it to install another one and the adhesive separated from the screen and Stu k to the watch face. It was hard to remove and I will not be installing another one.

It technically fits the screen however because it is shaped and not flat it leaves air bubbles in the corners where it doesn't quite press down on my screen. Because of the little air bubbles it won't stay in place even after leaving it overnight with books on top of it to flatten it after putting it on. I tried all of the suggestions from the instructions to get it to fit properly but it just wouldn't so I had to throw all of them away. Therefore definitely check your screen size beforehand and make sure it's a little bit bigger than your actual screen before buying it or else it won't stay on.

Does not fit the watchI don’t like the way it looks on the watch it’s too small but I wanted to watch to be covered at all times so I just kept it

Doesn’t fit my watch screen properly slightly to small even though it says 1.95 and I can’t get it to stop trying to lift off but it did protect my watch despite all that when I took a tumble so I guess it did it’s job

Touch screen great, Adhesion awesome, Install great gotta give attention to corner of the watch but that's an easy fixOther than that fits great on my 1.70" HD Full Touch ScreenDefinitely will buy again & tell folks about it💕🥂