Lamin-x Universal Yellow Fog Light Tint Film Covers (2-8 inch x 8 inch)

I recommend the DRY method. The stickiness is forgiving. Use a razor blade to chop off any lens you don’t want.

This stuff is just as advertised! I wanted it to cut some glare on a motorcycle highbeam...works like a CHAMP

Worked well on my Indian motorcycle fog lights. Took my time and got all air bubbles out. looks very nice.

Used to tint my auxiliary lights on my vehicle from clear to amber. Went on well. Recommend keeping a very sharpe blade when cutting.

Product was easily applied to my fog lights. And gives the vehicle a great look

I used this on a set of fog lights (technically "vent lights") for a 2023 Subaru BRZ. These lights are shaped strangely, so the material didn't form-fit around them very well. Luckily I could dismantle the lights to apply the film and the end product turned out better than I had hoped.The material certainly seems nice. It was much thicker than expected, which made it harder to flow around curved surfaces. I can see how this material will protect the lights from rock impacts.I would highly recommend this film for flat lenses. If you have a specific model of car that they have pre-cut shapes for, I would recommend that you go that route. I bought the film in 8" x 8" sheets and in the yellow color. I used most of one sheet and had a complete sheet that remained unused.

I have hand dexterity problems. The fog lights I wanted this product to be put on is only 2 inches maybe less making access to these tiny fog lights a challenge /unless you may need to remove foglights from vehicle. Lamin-X does not make pre-cut kits for my vehicle which are suppose to be an easier install. This being a universal kit is for the more advanced installs/if there is no pre-cut kit available for your vehicle as in my case. As previously mentioned I have hand dexterity problems and for this type of work it would be very very challenging if not a failure if I did it. I went to a shop who told me they wouldn't do the install with this universal kit. The shop recommended I get the pre-cut kit and then they would do the install which is fine by me. The problem here is that there is no pre-cut kit available for my vehicle per Lamin-X. Perhaps in the future there might be an pre-cut kit available then I might have this done so I can have foglights protected and have a better color in yellow for fog instead of the clear white light from factory on fog lights. At that point I would have shop do the install.

I bought this to use on my headlight of my motorcycle. It has two headlights and I covered one with the Lamin-x. Gives it a nice look that also catches peoples attention better. I have since added it to the driving lights of my truck and on another motorcycle. Easy to apply even on non flat surfaces, adheres well. Only wish it was just a little darker shade of yellow, but it does catch your attention.